Please enable JavaScript to view this site.

Manual InterForm400 English 2023

Navigation: » No topics above this level «

Getting started

Scroll Prev Top Next More

In order to get started you should consider the list below:

 

1.Restore InterForm400.

2.Install InterForm400.

3.Go into InterForm400 with the command, APF3812/APFMENU.

4.Configure InterForm400.

5.Add a license code.

6.Create file sets for your overlays/designs.

7.Add InterForm400 users.

8.Assign access to file sets for your InterForm400 users.

9.Install the graphical designer.

10.Install Swiftview if needed.

11.Now you can create overlays with the designers.

12.Automatic merges/flow is setup via Auto Forms Control.

13.Consider to start the Auto Forms Control subsystem, APF3812/AUTO_FORM at IPL.

14.Consider, if the other InterForm400 subsystems should be started with the AUTO_FORM subsystem.

 

Note: The library APF3812 should not be added to the library list of jobs in general. All jobs with the APF3812 library in the library list must e.g. be stopped before you can do an upgrade of InterForm400.